DM556 24V to 50V DC 1.50A to 5.6A 2 PH 42 57 Stepper Motor Driver KN90
Rp190,000.00
Tanya dulu via WhatsApp
DM556 24V to 50V DC 1.50A to 5.6A 2 PH 42 57 Stepper Motor Driver KN90
Features:
Step & direction or CW/CCW control
DSP-based stepper control technology
Maximum frequency: 200KHz
Input voltage: 20 – 50 VDC
Output current: 7 selections of 0.50 – 5.60A via DIP switches; or any value of 0.1-5.60A via software configuration
Micro steps: 15 selections of half – 128 step via DIP switches; or full – 512 step via software configuration
Automatic idle current reduction
Subdivision range: 400-25000ppr
Control Signal: 5V / 24V
Functions:
Anti resonance
Automatic motor identification and self configuration
Extra low noise
Extra smooth movement
Low drive & motor heating
Built-in micro-segmentation
Precision current control of the motor heat is greatly reduced
Optically isolated inputs, strong anti-jamming capability
Optically isolated differential signal input
Pulse signal: Pulse active at rising edge; 4-5V when PUL-HIGH, 0-0.5V when PUL-LOW. Minimal pulse width of 2.5μs. Add a resistor for current-limiting at +12V or +24V input logic voltage (1K for +12V, 2k for +24V). The same as DIR and ENA signals.
DIR signal:This signal has low/high voltage levels to represent two directions of motor rotation.. Minimal direction setup time of 5μs. Also swapping the connection of two wires of a coil (e.g. A+ and A-) to the drive will reverse motor direction.
Enable signal: This signal is used for enabling/disabling the drive. High level +5V (NPN control signal) for enabling the drive and low level for disabling the drive. PNP and Differential control signals are on the contrary, namely Low level for enabling. By default it is left UNCONNECTED (ENABLED).
Share:
Related Technical Articles
5 ulasan untuk DM556 24V to 50V DC 1.50A to 5.6A 2 PH 42 57 Stepper Motor Driver KN90
Hanya pelanggan yang telah membeli produk ini dapat memberikan ulasan.
Mungkin Anda suka
-
-
-
-
G3NA-410B DC5-24V Solid State Relay PV31
Rp390,000.00 -
-
Related Technical Articles
5 ulasan untuk DM556 24V to 50V DC 1.50A to 5.6A 2 PH 42 57 Stepper Motor Driver KN90
-
-
Barangnya udah sampe ssuai dengan deskripsi, semoga awet dan sesuai kebutuhan unit
-
Barangnya udah sampe ssuai dengan deskripsi, semoga awet dan sesuai kebutuhan unit
-
-
bagus
Hanya pelanggan yang telah membeli produk ini dapat memberikan ulasan.
Pilihan lainnya untukmu
Lihat produk terkait
Soli*** (pemilik terverifikasi) –
Must****** (pemilik terverifikasi) –
Barangnya udah sampe ssuai dengan deskripsi, semoga awet dan sesuai kebutuhan unit
Must****** (pemilik terverifikasi) –
Barangnya udah sampe ssuai dengan deskripsi, semoga awet dan sesuai kebutuhan unit
Reza (pemilik terverifikasi) –
Rasy** (pemilik terverifikasi) –
bagus