4 Axis CNC Engraving Control kit with Mach3 57 3A stepper driver AH20

4 Axis CNC Engraving Control kit with Mach3 57 3A stepper driver AH20

The kit can drive 42,50,57 ets two-phase stepper motor, using genuine professional stepper motor driver chip TB6560, adjustable drive current /low heat / performance stable /strong anti-interference ability / technology is mature, widely used in automation control, computer engraving machine, advertising / woodworking engraving machine, CNC lathe / CNC cutting machines, dispensers and other sophisticated devices.

Features:
– Supports XP and WINDOWS2000 Microsoft operating system
– Support a general-purpose parallel input and output design, direct support MACH2 / 3 control software, plus signal isolation and the bus driver IC signal drive capability and anti-jamming capability.
– 15-pin connector of Weihong sports card PC control software, giving you more choice
– Fully functional, directly support the four-axis output, emergency stop, knife, limit switches, the main Axis control, coolant control. A controlled group of relay outputs, all the optical coupling isolation, to protect the security of your computer parallel port.
– Blackboard process, clearly marked. Board size: 103 * 115MM, surrounded by a a 4MM fixed screw holes.

Note: use only one interface, you can not use both interfaces, such as using the MACH2 / 3 parallel port, you can not at the same time Weihong card interface. Note that good insulation, moisture, dust, and installation.

Including:

4* TB6560 driver
4* the new 57 3A stepper motor
1* MACH3 interface board
1* parallel interface Kable
1* Software